HP OMNIBER 718 HP 37718A - Manual (Page 20)

10
Setting the Interfaces
Setting Wander Transmit Interface
6 Choose the WANDER MASK setting required.
You can choose the wander modulating frequency and wander
amplitude if
is chosen.
If you choose , you can choose the "spot" wander frequency. The
wander amplitude is adjusted and controlled according to your wander
frequency choice.
SONET Wander (STS-3, OC-3, OC-12, OC-48)
7 Set up the SONET transmit interface. See “Setting SONET Transmit
Interface” page 4.
8 Choose JITTER/WANDER .
If you wish to add jitter to the SONET signal, see "Setting Jitter
Transmit Interface " page 7.
9 Choose WANDER .
10 Choose the WANDER MASK setting required.
You can choose the wander modulating frequency and wander
amplitude if
is chosen.
If you choose , you can choose the "spot" wander frequency. The
wander amplitude is adjusted and controlled according to your wander
frequency choice.
OFF
SPOT
WANDER
ON
OFF
SPOT