HP QMS 4060 - Manual (Page 88)

Communications
QMS 4060 Print System Reference 4-54
Setting Network 2 Options
CrownNet
For information on options and defaults found in this menu, see chap-
ter 2, “Printer Configuration,” in the
QMS CrownNet System Adminis-
trator’s Guide.
PS Protocol
Sets the binary communications protocol (BCP) for communicating
over a CrownNet interface to a PostScript printer.
Menu Administration/Communications/Network 2/PS
Protocol
Choices Normal—Enables standard, ASCII (7-bit) hex protocol.
Data is sent and received in ASCII format. This mode
is recommended if you do not print binary data. It was
designed for data in the printable ASCII range. Print
jobs can change this setting through PostScript
operators.
Normal Fixed—Enables standard, ASCII (7-bit) hex
protocol. Print jobs cannot change this setting through
PostScript operators.
Binary—Enables quoted binary communications
protocol (BCP). Print jobs can change this setting
through PostScript operators. Data in the printable
ASCII range also prints.