HP QMS 4060 - Manual (Page 60)

Operator Control
Menu
QMS 4060 Print System Reference 4-26
Setting Up Chaining Options
Options in the Operator Control menu allow you to configure whether
or not an inputbin will be available for chaining from another inputbin.
Large-Capacity Input Feeder (LCIF)
Use the Operator Control/Chain Option/LCIT Chaining to chain to the
optional tray.
Default On
Notes Use the Operator Control/Inputbin menu to set the
default inputbin. Make sure that the three inputbins
use the same size paper.
When chaining "on any" and duplexing, the printer will
chain to a similar size paper (for example, letter to A4)
but not to the large paper sizes—11"x17" and A3.
This is because these large sizes are fed through the
printer in a different printing order than the smaller
sizes. When these restrictions occur on chaining on
any, the printer will prompt you to add the default
paper size to any tray. The custom tray chaining
"on any" for large format- paper will not occur unless
there is another custom tray with the same paper size
or a standard tray with A3 or 11"x17" paper.
Menu Operator Control/Chain Option/LCIT Chaining
Choices On—Allow media to be pulled from the large-capacity
input tray.
Off—Don’t allow media to be pulled from the large-
capacity input tray.