HP QMS 4060 - Manual (Page 85)

Communications
4-51 Printer Configuration
Spooling Timeout
Sets the number of seconds the interface waits for data from the host
before terminating a spooled print job.
Data Bits
Sets the number of data bits transmitted per character.
End Job Mode
Enables (and identifies an end-of-job sequence) or disables data
stream sensing for the end-of-document (EOD) command.
Menu Administration/Communications/Parallel/Spool
Timeout
Choices 00000-99999
Default 00030
Menu Administration/Communications/Parallel/Data Bits
Choices 7, 8
Default 8
Menu Administration/Communications/Parallel/End Job
Mode
Choices None—The printer recognizes only the PostScript ^D
command.
QMS EOD—The printer recognizes only the QMS
%%EndOfDocument command.
HP EOD—The printer recognizes only the HP
%12345X command.