HP TC4100 User Manual
Page 77
75
Chapter 4
Error Messages
0800
Cache memory size
error
POST has detected the cache memory size is smaller than previously
detected.
To correct this:
1. If the processor module has just been replaced, press F4 to auto-
matically validate the change.
2. If the problem persists, the processor module may need to be
replaced.
0801
Cache boot error
POST has detected an error in the cache memory module.
To correct this:
1. Verify the processor module is installed correctly. Refer to “Mem-
ory Modules” in Chapter 3, “Installing TC4100 “ for handling pre-
cautions.
2. If the problem persists, the processor module may need to be
replaced.
0900
Integrated LAN disable
error
The system could not disable the integrated LAN.
To correct this:
1. Reset the Integrated LAN by powering off the HP Server.
2. Disconnecting the power cord for 20 seconds.
3. Reconnect the power cord and power on the HP Server.
4. If the error appears upon restarting, update the system BIOS.
5. Insert the HP Navigator CD-ROM in the CD-ROM drive and
power-cycle your system.
This will initialize the flash utility on HP Navigator CD-ROM.
6. If the error persists, the system board may need to be replaced.
Contact your service representative.
0901
Integrated LAN enable
error
The system could not enable the integrated LAN.
To correct this:
1. Reset the Integrated LAN by powering off the HP Server.
2. Disconnecting the power cord for 20 seconds.
3. Reconnect the power cord and power on the HP Server.
4. If the error appears upon restarting, update the system BIOS.
5. Insert the HP Navigator CD-ROM in the CD-ROM drive and
power-cycle your system.
This will initialize the flash utility on the HP Navigator CD-ROM.
6. If the error persists, the system board may need to be replaced.
Contact your service representative.
0A00
Display refresh rate
error
The parameters returned by the display do not match the DDC
standard used by the server for automatic setup of ergonomic refresh
rates.
To correct this:
1. Disable the 'Plug & Play Display' feature in the Setup Utility to
avoid a blank or unreadable screen at power-up.
2. Use the Setup Utility to manually set the video refresh rates to the
highest ergonomic refresh rates supported by the display. Refer to
display monitor's User's Guide for specifications.
Table 4-1. POST Error Codes
Code
Description
Problem/Solution