HP TC4100 - Manual (Page 37)

35
Chapter 3 Installing and Configuring
Installing Hot Swap Hard Drives
Use this section to install Hot Swap hard drives in the Hot Swap drive cage.
1. Ensure that the hard disk cage is unlocked, if it is locked, use the key to unlock it.
2. Remove the filler panel from the location you want the Hard Drive installed by simply pulling it straight out.
3. Open the drive module by pressing in on the locking latch at the center of the drive ejector handle and
pulling the handle open. See Figure 3-9 .
Figure 3-9. Opening the Drive Module
CAUTION Protect the drive from static electricity by leaving it in its antistatic bag until you are
ready to install it. Before handling the drive, touch any unpainted metal surface to
discharge static electricity. When you remove the drive from the antistatic bag, handle it
only by the frame.
Do not touch the electrical components. If you have to handle electrical components,
wear the antistatic strap. Place the drive on the antistatic bag whenever you set it down.
CAUTION To prevent snapping off the handle do not use extreme force when opening it. Open the
handle until you feel resistance.
1
3
2