HP TC4100 - Manual (Page 47)

45
Chapter 3 Installing and Configuring
Figure 3-16. System Board
Installing the Processor
The installation procedure is the same for the rack-mounted models as for the pedestal models of the Server
once you gain access to the system board.
1. Unpack the processor shipping box and check the contents against its packing list.
2. Gracefully shut down the network operating system according to directions in your NOS documentation.
3. Press the power switch on the HP Server tc4100's control panel when prompted by the operating system.
Normally, this completes the shutdown procedure.
4. Disconnect the power cords and any connected phone lines.
5. To gain access to the system board, follow the appropriate instructions for removing the cover.
• If the Server is mounted on the pedestal, perform Steps 1-8 from the “Removing Covers – Pedestal” on
page 25 .
CAUTION Use an antistatic wrist strap and a grounding mat.
Wear a wrist-strap and use a static-dissipating work surface connected to the chassis
when handling components. Ensure the metal of the wrist strap contacts your skin.
CAUTION Do not remove the processor from its bag until you are ready to install it and ensure the
bag remains sealed until then
WARNING Power supplies will continue to provide standby current to the Server until the power
cords are disconnected.
6
5
4
3
0 1 2 3
2
1
1
2
3
4
5