HP TC4100 - Manual (Page 43)

41
Chapter 3 Installing and Configuring
3. Locate the DIMM slot for installation and spread the two retaining clips outward. See Figure 3-14 .
Figure 3-14. Opening Retaining Clips
4. Ensure retaining clips are open and then align the notches on the DIMM with the keys on the DIMM slot,
holding the DIMM at a 90 ° angle to the system board. Figure 3-14 .
5. Insert the DIMM fully into the slot, handling the DIMM by its edges. See Figure 3-15 .
The retaining clips should grasp the DIMM automatically if it is inserted properly. If the clips do not close,
the DIMM is not inserted correctly.
Figure 3-15. Installing the DIMM
6. Re-install the Air Scoop.
CAUTION Do not rock the DIMM into place, but apply firm and even pressure. If the retaining clips
do not close, remove the DIMM and repeat Steps 5-6
Memory Board
(DIMM)
DIMM
Slot
Notch
(2 places)
Align Keys
with Notches
(2 places)
Close Retaining
Latches
(2 places)
1
2
2
DIMM
Open
Retaining Latches
(2 places)
2
1
3
2
Air
Scoop
NOTE: Remove the air scoop first
by unhooking the latch on top to
release it from fan enclosure
then lift it up.