HP TC4100 - Manual (Page 76)

74
Chapter 4 Error Messages
0540 Hard Disk Controller
resource conflict POST has detected an address space or IRQ resource conflict between
the integrated hard disk controller and an accessory board.
To correct this:
1. If the integrated hard disk controller is not needed, run the Setup
Utility to disable it (primary or secondary).
2. If the integrated hard disk controller is needed, the accessory
board's IRQ and address space must be reconfigured to use other
free resources. Refer to the accessory board installation manual
for information.
0600 Video Memory boot
error
(This does not apply to
tc4100) The video memory size detected during POST is smaller than
previously detected.
To correct this:
1. If you have changed your video adapter, press F4 to automatically
validate the change.
2. If the problem persists, the system board may need to be replaced.
Contact your service representative.
0700 DIMM size boot error The system memory size detected during the POST is smaller than
previously detected. One or several DIMMs are either disconnected,
or have been replaced by smaller ones.
To correct this:
1. If some main DIMMs have just been removed or replaced by
smaller ones, press F4 to automatically validate the change.
2. If no DIMM has been removed or changed, ensure all DIMMs are
properly inserted in the slots.
3. If the problem persists, one of DIMMs may need to be replaced.
Contact your service representative.
0712 DIMM installation
error POST has detected an incorrectly installed DIMM or the failure of
one or more DIMMs.
To correct this:
1. If additional memory was just installed in your server, please ver-
ify the installation conforms to the description in the User's Guide.
2. If this error was reported when no additional memory was just
installed, restart the server.
3. If the error persists, contact your service representative.
0713 Incorrect DIMM
installed POST has detected one or more DIMMs are not the correct type, or
the correct speed.
To correct this:
1. If additional memory was just installed in your server, please ver-
ify the correct DIMM type and speed for this server was installed.
Refer to the DIMM description in “Memory Modules” in Chapter
3, “Installing TC4100.”
2. If this error was reported when no additional memory was just
installed, restart the server.
3. If the error persists, contact your service representative.
Table 4-1. POST Error Codes
Code Description Problem/Solution