HP TC4100 User Manual

Page 68

Chapter 3

Installing and Configuring

10. Choose “Yes” and press Enter.

Then the HP Server tc4100 reboots.

Clearing CMOS

The Setup Utility provides a method of clearing CMOS from within the Utility. You may alsoclear the CMOS
of the configuration settings using the configuration switch on the system board.

Clearing CMOS via the Setup Utility

1. To clear CMOS from the BIOS Setup utility, press F11 during server POST when prompted to “Press F2

to enter Setup”. This will provide advanced features in the Setup utility.

2. From the Exit menu, select “Clear system configuration”.

3. Press F10 to save and exit the utility.

Clearing CMOS via the System Board Switches

1. To clear CMOS configurations using the System Board switch, power down the HP Server tc4100 and open

the side panel to gain access to the System Board.

2. On the system board, reset switch 4, on the configuration switch block, from Off (open) to On (closed). See

Figure 3-23

and

Table 3-3

Figure 3-23. Configuration Switch Block - Clearing CMOS

3. Power up the HP Server tc4100.

4. When you see a message diaplayed indicating that the configurations have been cleared, power off the HP

Server tc4100.

Table 3-3. Configuration Switch Block

Switch Number Switch On

Switch Off

Not Used

Clear Password

Keep Password

Clear CMOS

Keep CMOS

Not Used

Open = Off

Closed = On

Shaded rectangle
represents the
position of slide switch

OPE