Eaton Compressor & Fabrication C-STOV-MC001-E1 - Manual (Page 95)

EATON Char-Lynn Steering Catalog C-STOV-MC001-E1 July 2006 95
Sizing and
Application
Articulated Vehicle
Steering Analysis
Manufacturer __________________________________________________________________________________________________________
Vehicle Type ____________________________________________________________________________________________________________
Model Number ________________________________________________________________________________________________________
Completed By ____________________________________________________________________________ Date ________________________
Indicate Unit of Measurement Used ______________________________________________________________________________________
Clip out this form or photocopy when needed.
1. Turns Lock to Lock ____________________________________
2. Time Lock to Lock ____________________________________
3. Max. Steering Wheel RPM ______________________________
4. Cylinder Rod Diameter__________________________________
5. Cylinder Bore Diameter ________________________________
6. Cylinder Stroke ________________________________________
7. Pump: GPM Hi Idle ____________________________________
GPM Lo Idle __________________________________________
8. Steering Relief Pressure ________________________________
9. Auxiliary Relief Pressure ________________________________
10. Hydraulic Schematic (attach) ____________________________
11. B1 __________________________________________________
12. B2 __________________________________________________
13. C1 __________________________________________________
14. C2 __________________________________________________
15. E1 __________________________________________________
16. E2 __________________________________________________
17. S1 __________________________________________________
18. Weight - Front Axle
Unloaded ____________________________________________
19. Weight - Rear Axle
Unloaded ____________________________________________
20. Weight - Front Axle
Loaded ______________________________________________
21. Weight - Rear Axle
Loaded ______________________________________________
22. Articulation Angle (lock to lock) __________________________
23. Steering Circuit Line Size, Lengths, Type, Location (please
note on schematic ref. 10.) ______________________________
24. Is Steering Through Brakes
Statically Required? ____________________________________
25. Are Locking Differentials Used?
Front ________________ Rear ______________ Both ______________________
26. Is There A Differential Between the Front and Rear
Differentials? Yes ______________ No __________________
27. CG1 (Center of Gravity) ____________________________________
28. CG2 (Center of Gravity) ____________________________________
29. OS1 (Operator Seat)____________________________________
30. OS2 (Operator Seat)____________________________________
31. Weight - Front Bogey ______________________________________
32. Weight - Rear Bogey ______________________________________
33. I1 Mass Moment of Inertia (about CG1)
Front ______________________________________________________
34. I2 Mass Moment of Inertia (about CG2)
Rear__________________________________________________
35. Tire Size ______________________ Pressure ______________________
Width ____________________________ Ballast ________________________
Note:
1-10 Should always be completed; this information is needed for
basic steering system sizing.
1-26 Needed for sizing and an analysis of steering pressure
characteristics.
1-35 Needed for a full steering system analysis including
dynamic characteristics.