Xerox VersaLink C405/DN All-in-One Color Laser Printer - Manual (Page 242)

ENERGY STAR Qualified Product
The following configuration of this device is ENERGY STAR ® qualified under
the ENERGY STAR Program Requirements for Imaging Equipment:
Network printer with copy, automatic 2-sided printing, scan functions, fax
functions, and USB or network connectivity.
The ENERGY STAR and ENERGY STAR mark are registered United States
trademarks.
The ENERGY STAR Imaging Equipment Program is a team effort between United
States, European Union, and Japanese governments and the office equipment
industry to promote energy-efficient copiers, printers, fax, multifunction printers,
personal computers, and monitors. Reducing product energy consumption helps
combat smog, acid rain, and long-term changes to the climate by decreasing the
emissions that result from generating electricity.
ENERGY STAR settings are preset on Xerox ® equipment at the factory to switch to Power Saver modes
after 10 minutes from the last copy or print.
Power Consumption and Activation Time
The amount of electricity that a device consumes depends on the way the device is used. This device
is designed and configured to enable you to reduce your electricity usage.
Power Saver modes are enabled on your device to reduce energy consumption. After the last print,
the device transitions to Ready mode. In this mode, the device can print again immediately. If the
device is not used for a specified period, the device transitions to Low Power mode, then to Sleep
mode. In these modes, to enable reduced-power consumption, only essential functions remain active.
The device takes longer to produce the first print after it exits the Power Saver modes than it takes to
print in Ready mode. This delay is the result of the system waking up and is typical of most imaging
devices on the market.
To save power, you can enable Auto Power Off mode on your device. If Auto Power Off mode is
enabled, you can configure the mode as follows:
• Always Allowed : The device powers off automatically after the specified time, and the cumulative
Low Power mode and Sleep mode timeouts have elapsed.
• Allowed ONLY When Conditions are Met : The device automatically powers off only after
timeouts have elapsed. The device also powers off if Fax, USB Drive, and Wired and Non-Wired
Network have not been activated.
To change the Power Saver settings, refer to the User Guide at www.xerox.com/office/VLC405docs . For
further assistance, contact your System Administrator or refer to the System Administrator Guide .
To enable Auto Power Off mode, contact your System Administrator. For details, refer to the System
Administrator Guide at www.xerox.com/office/VLC405docs .
To learn more about Xerox participation in sustainability initiatives, go to: www.xerox.com/
environment .
Note: Changing the default Power Saver activation times can result in an overall higher energy
consumption of the device. Before you turn off Power Saver modes or set a long activation
time, consider the increase in device power consumption.
Default Power Saver Settings
This device is ENERGY STAR ® -qualified under the ENERGY STAR Program Requirements for Imaging
Equipment. The transition time from Ready mode to Low-Power mode can be set up to 60 minutes.
The default value is 10 minutes. The transition time from Low-Power mode to Sleep mode can be set
242 Xerox ® VersaLink ® C405 Color Multifunction Printer
User Guide
Regulatory Information