Xerox VersaLink C405/DN All-in-One Color Laser Printer - Manual (Page 200)

PPrriinntteerr iiss M Maakkiinngg U Unnuussuuaall N Nooiisseess
Probable Causes Solutions
There is an obstruction or debris inside the printer. Power off the printer, then remove the
obstruction or debris. If you cannot remove the
obstruction, contact your Xerox representative.
PPaappeerr TTrraayy W Wiillll N Noott C Clloossee
Probable Causes Solutions
The paper tray does not fully close.
• If the tray is extended for legal-size paper, the
tray protrudes when it is inserted into the printer.
For more information, refer to
Configuring Trays 1
or 2 for the Paper Length .
• Some debris or an object is blocking the tray.
• The tray is blocked by the table or shelf on which
it is located.
• If the paper lift plate at the back of the tray is not
locked down, replace the tray.
C Coonnddeennssaattiioonn hhaass FFoorrm meedd IInnssiiddee tthhee PPrriinntteerr
Moisture can condense inside a printer where the humidity is above 85% or when a cold printer is
located in a warm room. Condensation can form in a printer after it has been sitting in a cold room
that is heated quickly.
Probable Causes Solutions
The printer has been sitting in a cold room. Allow the printer to operate for several hours at room
temperature.
The relative humidity of the room is too high.
• Reduce the humidity in the room.
• Move the printer to a location where the
temperature and relative humidity are within the
operating specifications.
200 Xerox ® VersaLink ® C405 Color Multifunction Printer
User Guide
Troubleshooting