Change fax configurations, Fax dialing settings – HP MFP M528f Monochrome Laser Printer User Manual
Page 143

Change fax configurations
●
●
●
NOTE:
The settings configured using the control panel override any settings made in the HP Embedded Web
Server.
Fax dialing settings
1.
From the Home screen on the printer control panel, navigate to the
Settings
application, and then select
the
Settings
icon.
2.
Open the following menus:
●
Fax
●
Fax Send Settings
●
Fax Dialing Settings
Configure any of the following settings, and then select
Done
:
Menu item
Description
Redial on Error
The
Redial on Error
feature sets the number of times a fax number will be redialed when an
error occurs during a fax transmission.
Redial on No Answer
The
Redial on No Answer
setting selects the number of times the fax accessory redials if
the number dialed does not answer. The number of retries is either 0 to 1 (used in the U.S.)
or 0 to 2, depending on the location setting. The interval between retries is set by the redial
interval setting.
Redial on Busy
The
Redial on Busy
setting selects the number of times (0 through 9) the fax accessory
redials a number when the number is busy. The interval between retries is set by the Redial
Interval setting.
Redial Interval
The
Redial Interval
setting selects the number of minutes between retries if the number
dialed is busy or not answering, or if an error occurs.
NOTE:
You might observe a redial message on the control panel when both the
Redial on
Busy
and
Redial on No Answer
settings are set to off. This occurs when the fax accessory
dials a number, establishes a connection, and then loses the connection. As a result of this
error condition, the fax accessory performs three automatic redial attempts regardless of
the redial settings. During this redial operation, a message displays on the control panel to
indicate that a redial is in progress.
Fax Send Speed
The
Fax Send Speed
setting sets the modem bit rate (measured in bits per second) of the
Analog Fax modem while sending a fax.
●
Fast (v.34 – 33.6k)
●
Medium (v.17 – 14.4k)
●
Slow (v.29 – 9.6k)
Line Monitor Volume
Use the
Line Monitor Volume
setting to control the printer's dialing volume level when
sending faxes.
ENWW
Change fax configurations 129