KORG Pa300 Arranger - Manual (Page 145)

141 Sequencer
Song Edit: Transpose
Re
fe
rence
Bottom / Top Note
Use these parameters to set the bottom and top note of the key-
board range to quantize. If you select the same note as the Bot-
tom and Top parameters, you can select a single percussive
instrument in a Drum track.
Note: These parameters are available only when a Drum track is
selected.
Song Edit: Transpose
Here you can transpose the Song, a track or a part of a track.
After setting the various parameters, touch Execute to start the
operation.
Track
Use this parameter to select a track.
All All tracks selected (apart for Drum tracks).
Track 1…16 Selected track.
Value
Transpose value (±127 semitones).
Start / End Tick
Use these parameters to set the starting and ending points of the
range to transpose.
If you wish to select a four-measure sequence starting at the
beginning of the Song, the Start will be positioned at 1.01.000,
and the End at 5.01.000.
Bottom / Top Note
Use these parameters to set the bottom and top of the keyboard
range to transpose. If you select the same note as the Bottom and
Top parameters, you can select a single note, or a single percus-
sive instrument in a Drum track.
Song Edit: Velocity
Here you can change the Velocity value for the notes. An
Advanced mode is available, allowing you to select a velocity
curve for the selected range. This is useful to create fade-ins or
fade-outs.
After setting the various parameters, touch Execute to start the
operation.
Track
Use this parameter to select a track.
All All tracks selected.
Track 1…16 Selected track.
Value
Velocity change value.
Start / End Tick
Use these parameters to set the starting and ending points of the
range to edit.
If you wish to select a four-measure sequence starting at the
beginning of the Song, the Start will be positioned at 1.01.000,
and the End at 5.01.000.
Bottom / Top Note
Use these parameters to set the bottom and top of the keyboard
range to edit. If you select the same note as the Bottom and Top
parameters, you can select a single percussive instrument in a
Drum track.
Advanced
When this checkbox is checked, the “Intensity”, “Curve”, “Start
Velocity Value” and “End Velocity Value” parameters can be
edited.
Intensity
(Only available in Advanced mode). Use this parameter to specify
the degree to which the velocity data will be adjusted toward the
curve you specify in “Curve”.
0…100% Intensity value. With a setting of 0 [%], the veloc-
ity will not change. With a setting of 100 [%], the
velocity will be changed the most.