Extreme Networks 200 Series User Manual
Page 51
Common Commands
Summit 200 Series Switch Installation and User Guide
49
config sys-recovery-level [none | critical | all]
Configures a recovery option for instances
where an exception occurs in
ExtremeWare. Specify one of the
following:
•
none
—Recovery without system
reboot.
•
critical
—ExtremeWare logs an
error to the syslog, and reboots the
system after critical exceptions.
•
all
—ExtremeWare logs an error to the
syslog, and reboots the system after
any exception.
The default setting is
none
.
config time
Configures the system date and time. The
format is as follows:
mm/dd/yyyy hh:mm:ss
The time uses a 24-hour clock format. You
cannot set the year past 2036.
config timezone
Configures the time zone information to
the configured offset from GMT time. The
format of
gmt_offset
is +/- minutes from
GMT time. Specify:
•
autodst
—Enables automatic Daylight
Savings Time change.
•
noautodst
—Disables automatic
Daylight Savings Time change.
The default setting is
autodst
.
config vlan
{
Configures an IP address and subnet
mask for a VLAN.
create account [admin | user]
{encrypted} {
Creates a user account. This command is
available to admin-level users and to users
with RADIUS command authorization. The
username is between 1 and 32 characters,
the password is between 0 and 16
characters.
create vlan
Creates a VLAN.
delete account
Deletes a user account.
delete vlan
Deletes a VLAN.
disable bootp vlan [
Disables BOOTP for one or more VLANs.
disable cli-config-logging
Disables logging of CLI commands to the
Syslog.
disable clipaging
Disables pausing of the screen display
when a show command output reaches
the end of the page.
disable idletimeouts
Disables the timer that disconnects all
sessions. Once disabled, console sessions
remain open until the switch is rebooted or
you logoff. Telnet sessions remain open
until you close the Telnet client.
disable ports
Disables a port on the switch.
Table 14: Common Commands (continued)
Command
Description