Pim-sm commands – Extreme Networks 200 Series User Manual
Page 234
232
Summit 200 Series Switch Installation and User Guide
IP Multicast Routing and IGMP Snooping
PIM-SM Commands
Table 69 summaries the PIM-SM commands available on the Summit 200:
Table 69: PIM-SM Commands
Command
Description
configure pim {add | delete} {vlan}
Configures or unconfigures PIM-SM on an IP
interface. Specify the following:
•
add
—Configures PIM-SM on an IP interface.
•
delete
—Configures PIM-SM on an IP
interface.
•
vlan
—Configures or unconfigures PIM-SM on
all VLANs.
•
vlan name
—Configures or unconfigures
PIM-SM on a specific VLAN.
•
passive
—Enables or disables an interface
as passive. To specify an active interface,
omit this option.
configure pim crp static
Configures an RP and its associated groups
statically. The switch may not be configured
dynamically. Specify the following:
•
rp address
—The IP address of the
rendezvous point (RP).
•
access profile
—The list of multicast
group accesses served by the RP.
•
priority
—A priority setting. The range is 0 -
254.
configure pim register-checksum-to
[include-data | exclude-data]
Configures the checksum computation to either
include data or to exclude data in the register
message. Specify either:
•
include-data
—Use to be compatible with
Cisco Systems products.
•
exclude-data
—Use for RFC-compliant
operation.
configure pim spt-threshold
Configures the threshold for switching to SPT.
•
last hop router threshold
—The last
hop router threshold in Kbps.
•
rp threshold
—The rendezvous point (RP)
threshold in Kbps.