Extreme Networks 200 Series User Manual
Page 136
134
Summit 200 Series Switch Installation and User Guide
Access Policies
config ospf direct-filter [
none]
Configures the router to use the access policy to
limit the routes that are advertised into OSPF for
the switch as a whole for switches configured to
support direct route re-distribution into OSPF.
config rip vlan [
[
Configures RIP to suppress certain routes when
performing route advertisements.
config rip vlan [
[
Configures RIP to ignore certain routes received
from its neighbor.
config rip vlan [
[
Configures RIP to use the access list to
determine which RIP neighbor to receive (or
reject) the routes.
create access-profile
[ipaddress]
Creates an access profile. Once the access
profile is created, one or more addresses can be
added to it, and the profile can be used to control
a specific routing protocol.
Specify the following:
•
ipaddress
—A list of IP address and mask
pairs.
delete access-profile
Deletes an access profile.
show access-profile
Displays access-profile related information for the
switch.
Table 33: Routing Access Policy Configuration Commands (continued)
Command
Description