Extreme Networks 200 Series - Manual (Page 155)

Commands for Configuring and Monitoring EAPS
Summit 200 Series Switch Installation and User Guide 153
NOTE
The output displayed by this command depends on whether the node is a transit node or a master
node. The display for a transit node contains information fields that are not shown for a master node.
Also, some state values are different on a transit node than on a master node.
The following example of the show eaps {} detail command displays detailed EAPS
information for a transit node. Table 37 describes the fields and values in the display.
* Summit200-24:39 # show eaps detail
EAPS Enabled: Yes
Number of EAPS instances: 1
EAPSD-Bridge links: 2
Name: "eaps1" (instance=0)
State: Links-Up [Running: Yes]
Enabled: Yes Mode: Transit
Primary port: 13 Port status: Up Tag status: Tagged
Secondary port: 14 Port status: Up Tag status: Tagged
Hello Timer interval: 1 sec Fail Timer interval: 3 sec
Preforwarding Timer interval: 3 sec
Last update: From Master Id 00:E0:2B:81:20:00, Sat Mar 17 17:03:37 2001
Eaps Domain has following Controller Vlan:
Vlan Name VID
"rhsc" 0020
EAPS Domain has following Protected Vlan(s):
Vlan Name VID
"traffic" 1001
Number of Protected Vlans: 1
The following example of the show eaps {} detail command displays detailed EAPS
information for a single EAPS domain named “eaps2” on the master node. Table 37 describes significant
fields and values in the display.
* Baker15:4 # show eaps2 detail
Name: "eaps2" (instance=0)
State: Complete [Running: Yes]
Enabled: Yes Mode: Master
Primary port: 14 Port status: Up Tag status: Tagged
Secondary port: 13 Port status: Blocked Tag status: Tagged
Hello Timer interval: 1 sec Fail Timer interval: 3 sec
Eaps Domain has following Controller Vlan:
Vlan Name VID
"rhsc" 0020
EAPS Domain has following Protected Vlan(s):
Vlan Name VID
"blue" 1003
"traffic" 1001
Number of Protected Vlans: 2