Configuring rip – Extreme Networks 200 Series User Manual
Page 219
Configuring RIP
Summit 200 Series Switch Installation and User Guide
217
Configuring RIP
Table 63 describes the commands used to configure RIP.
Table 63: RIP Configuration Commands
Command
Description
config rip add vlan [
Configures RIP on an IP interface. When an IP
interface is created, per-interface RIP
configuration is disabled by default.
config rip delete vlan [
Disables RIP on an IP interface. When RIP is
disabled on the interface, the parameters are
not reset to their defaults.
config rip garbagetime {
Configures the RIP garbage time. The timer
granularity is 10 seconds. The default setting is
120 seconds.
config rip routetimeout {
Configures the route timeout. The default
setting is 180 seconds.
config rip rxmode [none | v1only | v2only | any]
{vlan
Changes the RIP receive mode for one or all
VLANs. Specify:
•
none
—Drop all received RIP packets.
•
v1only
—Accept only RIP v1 format
packets.
•
v2only
—Accept only RIP v2 format
packets.
•
any
—Accept both RIP v1 and v2 packets.
If no VLAN is specified, the setting is applied to
all VLANs. The default setting is
any
.
config rip txmode [none | v1only | v1comp |
v2only] {vlan
Changes the RIP transmission mode for one or
all VLANs. Specify:
•
none
—Do not transmit any packets on this
interface.
•
v1only
—Transmit RIP v1 format packets
to the broadcast address.
•
v1comp
—Transmit RIP v2 format packets
to the broadcast address.
•
v2only
—Transmit RIP v2 format packets
to the RIP multicast address.
If no VLAN is specified, the setting is applied to
all VLANs. The default setting is
v2only
.
config rip updatetime {
Changes the periodic RIP update timer. The
default setting is 30 seconds.
config rip vlan [
Configures the cost (metric) of the interface.
The default setting is 1.
enable rip
Enables RIP. The default setting is disabled.