Extreme Networks 200 Series - Manual (Page 191)

Displaying STP Settings
Summit 200 Series Switch Installation and User Guide 189
STP Configuration Example
The following Summit 200 series switch example creates and enables an STPD named Backbone_st. It
assigns the Manufacturing VLAN to the STPD. It disables STP on ports 1 through 7 and port 12.
create stpd backbone_st
config stpd backbone_st add vlan manufacturing
enable stpd backbone_st
disable stpd backbone_st port 1-7,12
Displaying STP Settings
To display STP settings, use the following command:
show stpd {}
This command displays the following information:
• STPD name
• Bridge ID
• STPD configuration information
To display the STP state of a port, use the following command:
show stpd port
This command displays the following information:
• STPD port configuration
• STPD state (root bridge, and so on)
• STPD port state (forwarding, blocking, and so on)
Disabling and Resetting STP
To disable STP or return STP settings to their defaults, use the commands listed in Table 53.
Table 53: Commands to Disable or Reset STP
Command Description
delete stpd Removes an STPD. An STPD can only be removed if all
VLANs have been deleted from it. The default STPD, s0,
cannot be deleted.
disable ignore-bpdu vlan Allows the switch to recognize STP BPDUs.
disable ignore-stp vlan Allows a VLAN to use STP port information.
disable stpd [ | all] Disables the STP mechanism on a particular STPD, or for
all STPDs.
disable stpd ports Disables STP on one or more ports. Disabling STP on
one or more ports puts those ports in forwarding state; all
BPDUs received on those ports will be disregarded.
unconfig stpd {} Restores default STP values to a particular STPD or to all
STPDs.