Extreme Networks 200 Series - Manual (Page 224)

222 Summit 200 Series Switch Installation and User Guide
Interior Gateway Routing Protocols
config ospf [vlan | area |
virtual-link ] timer
Configures the timers for one interface or all
interfaces in the same OSPF area. The
following default, minimum, and maximum
values (in seconds) are used:
• retransmission_interval
Default: 5
Minimum: 0
Maximum: 3,600
• transmission _ delay
Default: 1
Minimum: 0
Maximum: 3,600
• hello _ interval
Default: 10
Minimum: 1
Maximum: 65,535
• dead _ interval
Default: 40
Minimum: 1
Maximum: 2,147,483,647
config ospf add virtual-link Adds a virtual link to another ABR. Specify the
following:
• routerid —Far-end router interface
number.
• areaid —Transit area used for connecting
the two end-points.
config ospf add vlan area
{passive} Enables OSPF on one or all VLANs (router
interfaces). The
specifies the area
to which the VLAN is assigned. The passive
parameter indicates that the interface does not
send or receive OSPF packets.
config ospf area add range
[advertise | noadvertise]
[type 3 | type 7] Configures a range of IP addresses in an
OSPF area. If advertised, the range is exported
as a single LSA by the ABR.
config ospf area delete range
Deletes a range of IP addresses in an OSPF
area.
config ospf area normal Configures an OSFP area as a normal area.
The default setting is
normal .
config ospf area nssa [summary |
nosummary] stub-default-cost
{translate} Configures an OSPF area as a NSSA.
config ospf area stub [summary |
nosummary] stub-default-cost Configures an OSPF area as a stub area.
config ospf asbr-filter [ | none] Configures a route filter for non-OSPF routes
exported into OSPF. If
none is specified, no
RIP and static routes are filtered.
config ospf ase-limit {timeout
} Configures OSPF database overflow.
config ospf ase-summary add
cost {} Configures an aggregated OSPF external route
using the IP addresses specified.
Table 66: OSPF Configuration Commands (continued)
Command Description