ProSoft Technology 5105-103M-PDPS - Manual (Page 57)

5105-103M-PDPS ♦ ProLinx Gateway Diagnostics and Troubleshooting
IEC 60870-5-103 Master to PROFIBUS Slave Gateway User Manual
ProSoft Technology, Inc. Page 57 of 144
November 24, 2010
2.2.5 Opening the Session Configuration Menu
Press [P] from the Main Menu Menu to open the PROFIBUS Slave menu. Use
this command to view PROFIBUS Slave configuration information.
The PROFIBUS Slave Menu section has more information about the commands
on this menu.
2.2.6 Opening the IEC-103 Master Menu
Press [Q] from the Main Menu to open the IEC-870-5-103 Master Driver Menu.
Use this menu command to view detailed configuration information for the
module.
For more information about the commands on this menu, refer to IEC-103 Master
Driver Menu (page 69).
2.2.7 Sending the Configuration File
Press [S] to upload (send) a configuration file from the gateway to your PC.
2.2.8 Viewing Version Information
Press [V] to view version information for the gateway.
Use this command to view the current version of the software for the gateway, as
well as other important values. You may be asked to provide this information
when calling for technical support on the product.
Values at the bottom of the display are important in determining gateway
operation. The Program Scan Counter value is incremented each time a
gateway’s program cycle is complete.
Tip: Repeat this command at one-second intervals to determine the frequency of program
execution.
2.2.9 Opening the Data Map Menu
Press [$] to open the Data Map menu.