ProSoft Technology PLX81-EIP-61850 - Manual (Page 72)

Diagnostics and Troubleshooting PLX8x-EIP-61850 ♦ Communication Gateway
User Manual Server to
IEC 61850 Client
Page 72 of 167 ProSoft Technology, Inc.
July 2, 2015
4.7 Web Service and Gateway Web Page
When the gateway's IP address is accessed through a browser (such as Internet
Explorer) or the ProSoft Discovery Service, it shows the gateway's Web page.
The gateway's Web Services are connection-based, and therefore can accept
multiple connections at a time. Multiple users can view the gateway's Web page
at the same time.
Note: In order to access the web server the module must be booted with the MODE 3 jumper on. If
the module is booted with the MODE 3 jumper removed the web server is not started. Removing
the setup jumper and restarting after configuring the module or accessing the web page helps
prevent performance degradation from web server access while in run mode. Refer to Setting
Jumpers on page 11.
Functions
Firmware Upgrade Click to upgrade the firmware in the gateway. Only do this if
instructed to do so by ProSoft Technology Technical Support.
Set Date & Time Click to set the date and time in the gateway.
Reboot Module Click reboot the gateway.
Technical Support Click to be directed to the ProSoft Technology Technical Support
website.
Homepage
Click to go to the gateway’s homepage (shown above).