ProSoft Technology PLX81-EIP-61850 - Manual (Page 12)

Start Here PLX8x-EIP-61850 ♦ Communication Gateway
User Manual Server to
IEC 61850 Client
Page 12 of 167 ProSoft Technology, Inc.
July 2, 2015
1.4.2 PLX82-EIP-61850
For security reasons, the Mode 1 and Mode 2 jumpers are not readily accessible.
Under normal conditions, these two jumpers will not be needed. The following
diagram illustrates the available Setup Jumper setting.
Setup Jumper:
This mode is jumpered by default. It must be jumpered when performing a
firmware upgrade or when downloading a configuration file to the module.
For normal operation, this jumper should be hung on only one pin (not jumpered).
Removing the jumper allows for better communications between the IEC and
EtherNet/IP driver.
1.5 Mounting the Gateway on a DIN-rail