PLANET MAP-3100 - Manual (Page 9)

An Internet access network, as shown in figure below, is typically used to provide Internet
availability to a number of clients that connect to the mesh network. Alternatively, this
configuration can be used to provide access for client devices to remote resources on a
private network. There must be one or more gateway devices in such infrastructure that
provides access from the mesh network to an external network.
Note
1. The MAP-3100 supports 5 operating modes. Three for Layer 3, two for Layer
2.
2. At Layer 3 mode, multiple Gateways are allowed. At Layer 2 mode, only one
Gateway is allowed.
3. At the view of Mesh backhaul network, Layer 2 mode and Layer 3 mode
device can not co-existing to each other.
1.5 Wireless Performance
The following information will help you utilizing the wireless performance, and operating
coverage of MAP-3100.
1. Site selection
To avoid interferences, please locate MAP-3100 and wireless clients away from
transformers, microwave ovens, heavy-duty motors, refrigerators, fluorescent lights, and
other industrial equipments. Keep the number of walls, or ceilings between AP and clients
as few as possible; otherwise the signal strength may be seriously reduced.
It is suggested to carry out a site survey prior to installation to determine what devices are
Page 9 of 102