PLANET MAP-3100 - Manual (Page 68)

¾ Click on “Access Control” drop down menu to enable or disable access
control.
¾ Click on top “Apply” button if you have made any changes. New settings are
active after the device reboot.
¾ From “Configure” field, you can select “Modify” or “Remove” HTTPD.
¾ Add new HTTPD Access control page is as shown in Figure 3.5.1.2.
Figure 3.5.1.2: HTTPD Access Control – add page
HTTPD Access Control page contains the following parameters:
a. Device – Click on “Device” drop down menu to select device. For example WAN,
MESH, VLAN0……
b. Using – Click on “Using” drop down menu to select using “Device” or “Network”.
c. Comments – Enter comments for this entry.
d. Active – Click on “Active” drop down menu to enable or disable this entry.
e. “Apply” button – Click on “Apply” button to confirm add new HTTPD. New settings
are active after the device reboot.
f. If you select to edit existing HTTPD, a page similar to Figure 3.5.1.2 with configured
settings will be displayed.
Page 68 of 102