Programming introduction, Programming introduction -2 – RIGOL DM3058 User Manual
Page 7
RIGOL
Programming Guide for DM3058/DM3058E
1-2
Programming Introduction
The programming system provides an easy way for remote control through
corresponding commands, sending and identifying the command word with ASCII
strings. Connect a computer with the multimeter through communication interfaces
such as USB, GPIB*, LAN* or RS-232 before use.
The operations that you can do through the commands:
Setup the multimeter.
Make measurements.
Acquire data (instrument working condition or measurement results) from the
multimeter.
Note*: The GPIB and LAN interfaces are only supported by DM3058.