KACO Powador XP200-HV TL - Manual (Page 87)

Decommissioning/Dismantling
Operating Instructions Powador XP200-HV TL, XP250-HV TL, XP350-HV TL_EN Page 87
Electrician
14 Decommissioning/Dismantling
DANGER
Lethal voltages are still present in the terminals and lines of the inverter even after the inver-
ter has been switched off and disconnected!
Coming into contact with the lines and terminals in the inverter will cause serious injury or death.
Only authorised electricians who are approved by the supply grid operator may open, install and
maintain the inverter.
› Always shut down the inverter (in the sequence described below) before dismantling the unit.
› Do not touch exposed contact connections.
Switch off the inverter
1. Switch the main ON/OFF switch to OFF (stop the inverter).
2. Switch the power grid switch to OFF (disconnect the inverter from the grid).
3. Switch the DC disconnector to OFF (disconnect the inverter from the PV generator).
4. Make sure that the inverter is disconnected from all voltage sources.
5. Attach locking devices to the circuit breaker of the power grid connection and to the AC and DC disconnec-
tors.
6. Wait at least six minutes before working on the inverter.
Decommission and dismantle the inverter
1. Disconnect all terminals and cable fittings.
2. Remove all DC and AC leads.
3. Disconnect the connections and busbars between the cabinets.
15 Disposal
Dispose of the packaging materials
The packaging for the inverter consists of a wooden pallet, plastic foil made of polypropylene and the shipping
container.
" Dispose of the packaging materials in accordance with the applicable waste disposal regulations.
Dispose of the inverter
" After the inverter has reached the end of its service life, dispose of it in accordance with the applicable disposal
regulations for electronic waste or send it back to Kaco new energy GmbH (the address is on the back of these
instructions) at your own expense.