KACO Powador XP200-HV TL - Manual (Page 60)

User interface
Page 60 Operating Instructions Powador XP200-HV TL, XP250-HV TL, XP350-HV TL_EN
Parameter Unit Range Description Factory settings
COSPHI_9 – –0.999 ... –0.95
and 0.95 ... 1
Variable power factor reference accor-
ding to active power P_9.
1
P_9 % 0 ... 100 Active power setup conference for
COSPHI_9.
50
COSPHI_10 – –0.999 ... –0.95
and 0.95 ... 1
Variable power factor reference accor-
ding to active power P_10.
1
P_10 % 0 ... 100 Active power setup conference for
COSPHI_10.
50
Table 23: Controller parameters
8.5.8 Network parameters
Parameter Unit Range Description Factory settings
Configuration – 0 ... 10 0: DHCP
1: Static
1
IP – IP address (format: xxx.xxx.xxx.xxx) 1
Netmask – The subnet mask used for the network
(format: 255.255.255.0)
0
Gateway – Router address (format: xxx.xxx.xxx.xxx) 1
Table 24: Network parameters
8.5.9 Recording parameters
Parameter Unit Range Description Factory settings
Recording interval minute 10 ... 60 Time period for the recording of parameters 10
Grid power – ON (1)
OFF (0)
If deactivated, the grid power is not recorded. ON (1)
PV power – ON (1)
OFF (0)
If deactivated, the PV power is not recorded. ON (1)
PV voltage – ON (1)
OFF (0)
If deactivated, the PV voltage is not recorded. ON (1)
PV current – ON (1)
OFF (0)
If deactivated, the PV current is not recorded. ON (1)
PV temperature – ON (1)
OFF (0)
If deactivated, the PV temperature is not
recorded.
ON (1)
Irradiation – ON (1)
OFF (0)
If deactivated, the irradiation (insolation)
is not recorded.
ON (1)
Statistics reset – – All statistical data is reset. –
Table 25: Recording parameters