SMA STP 8000TL-10 - Manual (Page 73)

SMA Solar Technology AG 11 Messages
Installation Manual STP8-17TL-IA-en-31 73
11 Messages
11.1 Event Messages
During an update, the relevant display message is shown in the text line of the display.
No display messages if no DC voltage present
Measurements and the display of messages are only possible when there is sufficient
DC voltage (green LED flashing or glowing).
Message Description
< Inst. code valid > The SMA Grid Guard code entered is valid.
The configured country data set is now unlocked
and can be changed.
If the configured country data set is protected,
the unlocking is valid for a maximum of
10 feed-in hours.
< No new update SDcard > There is no relevant update file for this
Sunny Tripower on the SD card, or the present
update has already been executed.
< Grid param.unchanged > The selected switch setting is not programmed or
there is no country data set available on the
SD card.
< Parameters set successfully > All parameters of the SD card, e.g. country data
set, have been successfully adopted.
< SD card is read > The inverter is currently reading the SD card.
< Set parameter > The inverter is configuring the parameters from
the SD card settings.
< Self-test > The inverter is carrying out the self-test.
< Update completed > The inverter has successfully completed the
update.
< Update Bluetooth > Update of the Bluetooth component successful.
< Update display > Update of the display successful.
< Update main CPU > Update of the inverter component successful.
< Update communication > Update of communication component successful.
< Update string prot. > Update of electronic string fuse successful.
< Update RS485I module > Update of communication interface successful.
< Upd. language table > Update of language table successful.
< Update file OK > The update file found is valid.