SMA STP 8000TL-10 - Manual (Page 38)

6 Electrical Connection SMA Solar Technology AG
38 STP8-17TL-IA-en-31 Installation Manual
4. Push the swivel nut up to the thread and tighten (torque: 2.0 Nm).
☑ The DC connectors are assembled and ready for connection to the inverter (see Section 6.4.4
"Connecting the PV Array (DC)", page 40).
Result Measure
☑ If the stranded wire is visible in the
chamber of the clamping bracket, the
cable is correctly positioned.
• Proceed to step 4.
☑ If the stranded wire is not visible in the
chamber, the cable is not correctly
positioned.
• Release the clamping bracket. To do so,
insert a 3.5 mm screwdriver into the
clamping bracket and lever it open.
• Remove the cable and go back to step 1.