SMA STP 8000TL-10 - Manual (Page 21)

SMA Solar Technology AG 5 Mounting
Installation Manual STP8-17TL-IA-en-31 21
5.2 Selecting the Mounting Location
Take the following requirements into consideration when selecting the mounting location:
• The mounting method and location must be suitable for the weight and size of the inverter
(see Section 14 "Technical Data", page 95).
• Mount on a solid surface.
• The mounting location must be clear and safely accessible at all times without the use of
additional aids such as scaffolding or lifting platforms. If this is not the case, service work may
be restricted.
• Mount vertically or tilted backwards by max. 15°.
• The connection area must point downwards.
• Never mount the device with a forward tilt.
• Never mount the device with a sideways tilt.
• Do not mount horizontally.
• Install the inverter at eye level. Given the weight of the device, this will facilitate disassembly for
service work.
• The ambient temperature should be below 40°C to ensure optimum operation.
• Do not expose the inverter to direct solar irradiation as this could cause power derating due to
overheating.
• In order to avoid audible vibrations in living areas, do not mount the unit on plasterboard walls
or similar. When in operation, the inverter emits noise which may be perceived as annoying in
living areas.
max. 15°