SMA STP 8000TL-10 - Manual (Page 54)

6 Electrical Connection SMA Solar Technology AG
54 STP8-17TL-IA-en-31 Installation Manual
To do this, proceed as follows:
1. Disconnect the inverter (see Section 9 "Disconnecting the Inverter from Voltage Sources",
page 63).
2. Set the arrow on the rotary switch (C) to the
required position with a screwdriver. Use a
screwdriver with blade width 2.5 mm.
3. Restart the inverter (see Section 7 "Commissioning", page 58).
Activation of settings
The Bluetooth settings will only be activated after the miniature circuit-breaker has been
switched on, the PV array connected and the Electronic Solar Switch plugged in.