SMA CLUSTER CONTROLLER Installation - Manual (Page 39)

3. Call up the IP address of the Cluster Controller via the web browser.
☑ The login page opens:
✖ The login page does not open?
Possible error cause: you have not written down the IP address correctly or you have not
entered it correctly.
• Enter the correct IP address and confirm the entry with the enter key.
• If the problem persists, read the troubleshooting information (see Section 7.2 "Errors
in the Cluster Controller or the Connected Devices", page 76).
4. Select the desired language in the upper area of the login page.
5. Log in either as User or as Installer with the corresponding default system password for the
user group. This makes the language change take effect on the user interface and on the
display:
User group Default system password
User 0000
Installer 1111
☑ The user interface opens.
✖ The user interface does not open?
Cause: You have not entered the default system password for the selected user group
correctly.
• On the login page, enter the correct default system password for the selected user
group and confirm the entry with the enter key.
6. Select the Cluster Controller in the system tree and select the menu Settings in the device
menu.
7. Select the parameter group Device > Time settings.
8. If required, use the drop-down list Standard/daylight saving time conversion on to set
automatic conversion between standard and daylight saving time.
9. In the field Set system time, set the current date and time of the system.
10. In the drop-down list Time zone, select the time zone in which the system is located.
11. Select [Save].
☑ The system time is updated.
12. Select [Logout] in the toolbar.
6 Connection and Commissioning SMA Solar Technology AG / SMA America, LLC
Installation Manual 39 ClusterController-IA-en-14