SMA SUNNY HOME MANAGER - Manual (Page 122)

15 Troubleshooting SMA Solar Technology AG
122 HoMan_Portal-BA-en-17 User Manual
The SMA radio-controlled
socket does not switch the
dishwasher on even though
start-up detection is activated. For the Start-up detection function, the SMA radio-controlled
socket must have at least firmware version 12.12.111.R. You can
read off the firmware version via the parameter Software
package (see Section 8.5, page 55).
Corrective measures:
1. If the SMA radio-controlled socket has a firmware version
lower than 12.12.111.R, ensure that the automatic
software update is activated for the devices in the PV system
(see Section 8.8, page 57). This way, the
SMA radio-controlled socket will receive the latest firmware
version within 24 hours.
2. If you had already configured start-up detection before the
firmware update of the SMA radio-controlled socket,
proceed as follows once the firmware update has been run
successfully:
• Call up the load properties of the dishwasher
(see Section 9.3.1, page 65).
• Select [Edit] and then immediately [Save]. This way,
the settings for start-up detection will be transmitted to
the SMA radio-controlled socket again.
Problem Cause and corrective measures