HEIDENHAIN iTNC 530 (340 49x-02) ISO programming - Manual (Page 85)

HEIDENHAIN iTNC 530 85
2.6 Dynamic Collision Monit
o
ri
ng (Sof
tw
ar
e Option)
Collision monitoring in Automatic operation
The TNC monitors motions blockwise, i.e. it outputs a warning in the
block which would cause a collision, and interrupts program run. A
reduction of the feed rate, as with Manual Operation, does not occur.
The handwheel superimpositioning function with M118 is
not possible in combination with collision monitoring.