HEIDENHAIN iTNC 530 (340 49x-02) ISO programming - Manual (Page 617)

Table of Miscellaneous Functions
M Effect Effective at block Start End Page
M00 Stop program/Spindle STOP/Coolant OFF „ Page 231
M01 Optional program STOP „ Page 539
M02 Stop program/Spindle STOP/Coolant OFF/Clear status display
(depending on machine parameter)/Go to block 1 „ Page 231
M03
M04
M05 Spindle ON clockwise
Spindle ON counterclockwise
Spindle STOP „
„
„
Page 231
M06 Tool change/Stop program run (depending on machine parameter)/Spindle STOP „ Page 231
M08
M09 Coolant ON
Coolant OFF „
„
Page 231
M13
M14 Spindle ON clockwise/Coolant ON
Spindle ON counterclockwise/Coolant ON „
„
Page 231
M30 Same function as M02 „ Page 231
M89 Vacant miscellaneous function or
Cycle call, modally effective (depending on machine parameter) „
„
Page 265
M90 Only in lag mode: Constant contouring speed at corners „ Page 235
M91 Within the positioning block: Coordinates are referenced to machine datum „ Page 232
M92 Within the positioning block: Coordinates are referenced to position defined by machine
tool builder, such as tool change position „ Page 232
M94 Reduce display of rotary axis to value under 360° „ Page 252
M97 Machine small contour steps „ Page 237
M98 Machine open contours completely „ Page 239
M99 Blockwise cycle call „ Page 265
M101
M102 Automatic tool change with replacement tool if maximum tool life has expired
Reset M101 „
„
Page 179
M103 Reduce feed rate during plunging to factor F (percentage) „ Page 240
M104 Reactivate the datum as last defined „ Page 234
M105
M106 Machining with second k
v
factor
Machining with first k
v
factor
„
„ Page 588
M107
M108 Suppress error message for replacement tools
Reset M107 „
„
Page 178