HEIDENHAIN iTNC 530 (340 49x-02) ISO programming - Manual (Page 269)

HEIDENHAIN iTNC 530 269
8.2 P
oint
T
a
bles
Hiding single points from the machining process
In the FADE column of the point table you can specify if the defined
point is to be hidden during the machining process (see “Optional
Block Skip” on page 538).
In the table, select the point to be hidden.
Select the FADE column
Activate the hiding, or
Deactivate the hiding
Selecting a point table in the program
In the Programming and Editing mode of operation, select the
program for which you want to activate the point table:
Press the PGM CALL key to call the function for
selecting the point table.
Press the POINT TABLE soft key.
Enter the name of the point table and confirm your entry with the END
key.
Example NC block
N72 %:PAT: “NAMES“ *