HEIDENHAIN iTNC 530 (340 49x-02) ISO programming - Manual (Page 215)

HEIDENHAIN TNC iTNC 530 215
6.5 P
a
th Cont
ours—P
olar Coor
dinat
e
s
Straight line at rapid traverse G10
Straight line with feed rate G11 F . . .
The tool moves in a straight line from its current position to the
straight-line end point. The starting point is the end point of the
preceding block.
Programming
8 Polar coordinates radius R: Enter distance from the
straight line end point to the pole I, J
8 Polar-coordinates angle H: Angular position of the
straight-line end point between –360° and +360°
The sign of H depends on the angle reference axis:
„ Angle from angle reference axis to R is counterclockwise: H >0
„ Angle from angle reference axis to R is clockwise: H <0
Example NC blocks
Circular path G12/G13/G15 around pole I, J
The polar coordinate radius R is also the radius of the arc. It is defined
by the distance from the starting point to the pole I, J. The last
programmed tool position before the G12, G13 or G15 block is the
starting point of the arc.
Direction
„ In clockwise direction: G12
„ In counterclockwise direction: G13
„ Without programmed direction: G15. The TNC traverses the circular
arc with the last programmed direction of rotation.
Programming
8 Polar-coordinates angle H: Angular position of the arc
end point between –5400° and +5400°
Example NC blocks
N120 I+45 J+45 *
N130 G11 G42 R+30 H+0 F300 M3 *
N140 H+60 *
N150 G91 H+60 *
N160 G90 H+180 *
X
Y
45
25
60°
60°
30
CC
11
N180 I+25 J+25 *
N190 G11 G42 R+20 H+0 F250 M3 *
N200 G13 H+180 *
X
Y
25=I
25=J
R20
13