HEIDENHAIN iTNC 530 (340 49x-02) ISO programming - Manual (Page 65)

HEIDENHAIN iTNC 530 65
2.2 Mo
ving the Mac
hine Ax
es
Features in the Program Run modes of operation
You can use the following functions in the Program Run modes of
operation:
„ NC start (handwheel NC-start key)
„ NC stop (handwheel NC-stop key)
„ After the NC-stop key has been pressed: Internal stop (handwheel
soft keys MOP and then STOP)
„ After the NC-stop key has been pressed: Manual axis traverse
(handwheel soft keys MOP and then MAN)
„ Returning to the contour, after the axes were moved manually
during a program interruption (handwheel soft keys MOP and then
REPO
). Operation is by handwheel soft keys, which function similarly
to the control-screen soft keys (see “Returning to the contour” on
page 536)
„ On/off switch for the Tilted Working Plane function (handwheel soft
keys MOP and then 3D)