HEIDENHAIN iTNC 530 (340 49x-02) ISO programming - Manual (Page 8)

8
Functions new since the
predecessor versions 340 422-xx
and 340 423-xx
„ A new form-based operating mode, smarT.NC, has been
introduced. These cycles are described in a separate user's
document. In connection with this the TNC operating panel was
enhanced. There are some new keys available for quicker navigation
within smarT.NC (see “Operating panel” on page 41).
„ The single-processor versions supports pointing devices (mice) via
the USB 2.0 interface.
„ New CENTERING cycle (see “CENTERING (Cycle 240)” on page 274)
„ New M function M150 for suppressing limit switch messages (see
“Suppress limit switch message: M150” on page 249)
„ M128 is now also permitted for mid-program startup (see “Mid-
program startup (block scan)” on page 534).
„ The number of available Q parameters was expanded to 2000 (see
“Programming: Q Parameters” on page 483).
„ The number of available label numbers was expanded to 1000. Now
label names can be assigned as well (see “Labeling Subprograms
and Program Section Repeats” on page 468).
„ In the Q parameter functions D9 to D12 you can now also assign
label names as jump targets (see “If-Then Decisions with
Q Parameters” on page 492).
„ The current time is also shown in the additional status display
window (see “General program information” on page 46).
„ Several columns were added to the tool table (see “Tool table:
Standard tool data” on page 167).
„ The Test Run can now also be stopped and continued within
machining cycles (see “Running a program test” on page 528).