HEIDENHAIN iTNC 530 (340 49x-02) ISO programming - Manual (Page 76)

76 2 Manual Operation and Setup
2.4 D
a
tu
m Set
ting (Without a 3-D T
ouc
h Pr
obe)
Activating the datum from the preset table in the Manual
Operation mode
Select the Manual Operation mode.
Display the preset table.
Select the datum number that you want to activate, or
With the GOTO key, select the datum number that
you want to activate. Confirm with the ENT key.
Activate preset.
Confirm activation of the datum. The TNC sets the
display and—if defined—the basic rotation.
Leave the preset table.
Activating the datum from the preset table in an NC program
To activate datums from the preset table during program run, use
Cycle 247. In Cycle 247 you define the number of the datum that you
want to activate (see “DATUM SETTING (Cycle G247)” on page 425).
When activating a datum from the preset table, the TNC
resets all coordinate transformations that were activated
with the following cycles:
„ Cycle 7, Datum Shift
„ Cycle 8, Mirroring
„ Cycle 10, Rotation
„ Cycle 11, Scaling
„ Cycle 26, Axis-Specific Scaling
However, the coordinate transformation from Cycle 19,
Tilted Working Plane, remains active.