Grass Valley K2 Media Client Service Manual v.3.3 - Manual (Page 98)

98 K2 Media Client Service Manual June 25, 2009
Chapter 4 Troubleshooting problems
RAID controller BIOS startup information
During startup, the screen that displays RAID controller information varies,
depending on if the K2 Media Client provides the functionality via the SCSI
controller adapter or via the motherboard. To identify, check for the SCSI controller
adapter installed in a PCI slot and visible at the K2 Media Client rear panel.
Startup screen for systems with SCSI controller adapter
If the K2 Media Client has a SCSI controller adapter, the following information
appears on the locally connected VGA monitor during a normal startup of the K2
Media Client. This is a part of the BIOS Power On Self Test (POST) generated by the
SCSI controller adapter.
Startup screen for systems without SCSI controller adapter
If the K2 Media Client does not have a SCSI controller adapter, the following
information appears on the locally connected VGA monitor during a normal startup
of the K2 Media Client. This is a part of the BIOS Power On Self Test (POST)
generated by the SCSI controller adapter.
Information Explanation
LSI MegaRAID BIOS Version… SCSI controller adapter BIOS and firmware
version information
Copyright… Copyright information for the manufacturer of the
SCSI controller adapter.
Initializing SCSI controllers
Scanning…
Checking…
Spinning…
Reading… This list of flashing messages refer to the startup of
the internal RAID drives and their supporting
components.
HA-1 (Bus 3 Dev 0) MegaRAID SCSI 320-2X Report of the SCSI controller adapter
Standard FW 413Z DRAM = 128 MB (SDRAM) Report of firmware and memory installed on the
SCSI controller adapter.
6 Logical drives found… A report of the LUNs (groups of RAID drives)
currently installed. Internal storage models have
multiple LUNs. External storage models have one
LUN.
6 Logical drives handled…
Press to run Configuration Utility This is the SCSI controller adapter configuration.
Do not press these keys. All settings should be left
at their default values.
Press for WebBIOS
Information Explanation
Adaptec Embedded SATA HostRAID BIOS SATA disk controller BIOS and firmware version
information