Grass Valley K2 Media Client Service Manual v.3.3 - Manual (Page 92)

92 K2 Media Client Service Manual June 25, 2009
Chapter 3 Service Procedures
c. Select Have Disk .
d. Browse to C:\profile\drivers\LSI_SCSIPORT_1.21.25.00. Click Open and OK .
e. Start the driver install by selecting Next .
f. On the Hardware Installation page, click Continue Anyway .
g. Click Finish .
6. If the K2 Media Client is on a redundant K2 Storage System, do the following:
a. Install MPIO as instructed in the K2 Media Client System Guide.
b. Make the following registry settings:
[HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Service
s\Symmpi\Parameters\Device]
"DriverParameter"="MPIOMode=2"
"MaximumSGList"=dword:000000ff
"NumberOfRequests"=dword:00000020
NOTE: A previous procedure included registry setting EnablePseudoDevice=1.
This setting is no longer required; however, if set, it does no harm.
Replacing a K2 Media Client
To correct some system faults Grass Valley Support sends you a replacement K2
Media Client. Contact Grass Valley Support if you think you need a replacement K2
Media Client.