Grass Valley K2 Media Client Service Manual v.3.3 - Manual (Page 46)

46 K2 Media Client Service Manual June 25, 2009
Chapter 2 System Messages
System cache error - Cache disabled RAM cache failed and BIOS disabled the cache.
On older boards, check the cache jumpers. You
may have to replace the cache. See your dealer. A
disabled cache slows system performance
considerably.
CPU ID: CPU socket number for Multi-Processor error.
EISA CMOS not writeable ServerBIOS2 test error: Cannot write to EISA
CMOS.
DMA Test Failed ServerBIOS2 test error: Cannot write to extended
DMA (Direct Memory Access) registers.
Software NMI Failed ServerBIOS2 test error: Cannot generate software
NMI (Non-Maskable Interrupt).
Fail-Safe Timer NMI Failed ServerBIOS2 test error: Fail-Safe Timer takes too
long.
device Address Conflict Address conflict for specified device.
Allocation Error for: device Run ISA or EISA Configuration Utility to resolve
resource conflict for the specified device.
CD ROM Drive CD ROM Drive identified.
Entering SETUP… Starting Setup program
Failing Bits: nnnn The hex number nnnn is a map of the bits at the
RAM address which failed the memory test. Each
1 (one) in the map indicates a failed bit. See errors
230, 231, or 232 above for offset address of the
failure in System, Extended, or Shadow memory.
Fixed Disk n Fixed disk n (0-3) identified.
Invalid System Configuration Data Problem with NVRAM (CMOS) data.
I/O device IRQ conflict I/O device IRQ conflict error.
PS/2 Mouse Boot Summary Screen: PS/2 Mouse installed.
nnnn kB Extended RAM Passed Where nnnn is the amount of RAM in kilobytes
successfully tested.
nnnn Cache SRAM Passed Where nnnn is the amount of system cache in
kilobytes successfully tested.
nnnn kB Shadow RAM Passed Where nnnn is the amount of shadow RAM in
kilobytes successfully tested.
nnnn kB System RAM Passed Where nnnn is the amount of system RAM in
kilobytes successfully tested.
One or more I2O Block Storage
Devices were excluded from the Setup
Boot Menu There was not enough room in the IPL table to
display all installed I2O blockstorage devices.
Operating system not found Operating system cannot be located on either drive
A: or drive C:. Enter Setup and see if fixed disk
and drive A: are properly identified.
BIOS Message Description