Grass Valley K2 Media Client Service Manual v.3.3 User Manual
Page 87
June 25, 2009
K2 Media Client Service Manual
87
Restoring from the generic recovery disk image on E:
13. You are restoring both the C: partition and the D: partition, so select
Yes, I want to
restore another partition or hard disk drive
and then click
Next
.
The Partition or Disk to Restore page opens. Continue with the next step in this
procedure.
14. Select
Database (D:)
and then click
Next
.
The Restored Partition Location page opens.
15. Select
Database (D:)
and then click
Next
.
The Restored Partition Type page opens.
16. Leave the selection at
Primary
and then click
Next
.
The Restored Partition Size page opens.
17. Leave settings at their defaults. The size reported in the upper pane is the size
detected of the actual D: partition. This should be the same as that reported in the
Partition size field in the middle of the page. Free space before and Free space after
should both be reported at 0 bytes. Click
Next
.
The Next Selection page opens.
18. Select
No, I do not
and then click
Next
.
The Restore Operation option page opens.
19. Do not make any selections. Click
Next
.
The “…ready to proceed…” page opens.
20. Verify that you are restoring the correct partition or partitions. Click
Proceed
.
The Operation Progress page opens and displays progress.
21. When a “The data was successfully restored” message appears, click
OK
.
22. Click
Operations | Exit
to exit the Acronis True Image program.
The K2 Media Client restarts automatically.
23. Remove any CD currently in the CD drive while the K2 Media Client is shutting
down.
24. Upon restart the Windows Setup Wizard automatically opens. Do Windows setup
as follows:
a. Enter in Windows Product Key and click
Next
.
The Product Key is on a sticker on the right side of the K2 Media Client Chassis.
b. Enter the name of the K2 Media Client.
The factory default name is on a label near the power button.
The password is pre-set to the factory default. Leave the password as is.
c. Click
Next
d. Set Time and click
Next
.
Windows loads network components and restarts the K2 Media Client.
Upon restart, a Found New Hardware wizard and/or messages about services/
drivers can be displayed.