Grass Valley K2 Media Client Service Manual v.3.3 - Manual (Page 68)

68 K2 Media Client Service Manual June 25, 2009
Chapter 3 Service Procedures
order adapters as follows:
4. Click OK to close Advanced settings and accept the changes.
5. Close the Network Properties window.
Set power management settings
1. On the Windows desktop right-click My Network Places and select Properties .
The Network Connections window opens.
2. Identify the network connections that are actual network adapters and not a team.
The actual network adapters should have names as follows:
• Control Connection #1
• Control Connection #2
• Media Connection #1
• Media Connection #2
3. Right-click any of the actual network adapters (do not select a team) and select
Properties .
The …Connection Properties dialog box opens.
4. Click Configure .
The …Properties dialog box opens.
5. On the Power Management tab, uncheck all checkboxes, if they are not already
unchecked.
6. On the …Properties dialog box, click OK .
7. Repeat these steps on the remaining actual network adapters (not a team) in the
Network Connections window.
The network configuration procedure is complete.
Configuring Event Viewer
If you have a problem with the Windows Event Viewer logs getting too big, configure
as follows:
1. From the Windows taskbar click Start | Control Panel . Open Administrative Tools |
Computer Management .
Internal storage
unteamed Internal storage
teamed Direct-connect
storage Shared (SAN) storage
Loopback Loopback Loopback Control Team
Control Connection #1 Control Team Control Connection #1 Media Connection #1
Control Connection #2 FTP Team Media Connection #1 Media Connection #2
Media Connection #1 — — Loopback
Media Connection #2 — — —