Grass Valley K2 Media Client Service Manual v.3.3 - Manual (Page 120)

120 K2 Media Client Service Manual June 25, 2009
Chapter 5 Removing and replacing FRUs
Internal Parts Removal
The sections that follow show how to remove internal parts from the K2 Media Client.
• “Top cover removal” on page 121
• “SCSI interface board removal” on page 122
• “Removable media drive removal” on page 123
• “Codec board removal” on page 124
• “Mezzanine board removal” on page 126
• “RTP board removal” on page 127
• “Rear card guide removal” on page 128
• “SCSI backplane removal” on page 129
• “SATA drive connector board removal” on page 131
• “RS-422 adapter removal” on page 133
• “Graphics board removal” on page 135
• “Dual Ethernet adapter removal” on page 136
• “SCSI controller adapter removal” on page 137
• “XLR board removal” on page 138
• “Center support bracket removal” on page 139
• “CPU motherboard replacement” on page 140
CAUTION: To avoid possible damage to circuit boards and other
sensitive parts, turn off the K2 Media Client and disconnect AC power
before opening the top cover or removing any internal parts.
!