Grass Valley K2 Media Client Service Manual v.3.3 - Manual (Page 130)

130 K2 Media Client Service Manual June 25, 2009
Chapter 5 Removing and replacing FRUs
When installing replacement, ensure the LED solder ends clear the cut outs and are
not shorting against the bracket.
Remove six screws 6
Remove two screws 7
Remove bar 8
Disengage connector
from SCSI interface board 9
Carefully slide SCSI
backplane to the rear to
disengage the 12 LEDS
Slide backplan to the
side and rotate up to
remove 11
10